Tape production process
1. The whole process of belt production is as follows:
The width of plastic film is about 1.3m
According to the use of tape. Then choose different plastic particles and add some special additives


2. After blowing the film, put the film on the coater to coat the glue;
In fact, this process is mainly based on the viscosity and use of tape to choose glue, and so after coating is tape
It's just that the current one is still 1.3m wide, hundreds of meters long and has a large roll of plastic film. It's not separated.

3. Then, the large roll of plastic film needs to be rewound into a small roll through the rewinder;
This can be rewound according to the length of the tape we usually use.

4. The rewinding small film can be cut into the required width of the tape by the slitter;
For example, 1cm width or other widths are OK

Tape production is the biggest impact on the quality of the link is blown film and coating these two processes
Because these two processes are semi-finished products, and the later rewinding and slitting have less impact on the tape.
As long as you learn the process, you can basically mass produce the tape. Almost everyone who runs a tape factory can make tape. Tape is widely used in daily life, industry and agriculture. The types of tape may be different. Generally, thick insulating tape is used in industry, but the tape in daily life is usually transparent. However, the thickness ratio is relatively thin. Different tapes are made in the same way, but they are also different.